pulley block
英 [ˈpʊli blɒk]
美 [ˈpʊli blɑːk]
滑轮组
英英释义
noun
- a simple machine consisting of a wheel with a groove in which a rope can run to change the direction or point of application of a force applied to the rope
双语例句
- Under the state of equivalent maximum stress, the contact friction condition of metal belt and pulley was simulated by the contact of ring and block in Timken Friction Test Machine.
以接触应力相等为等效的接触状态，采用环块摩擦实验机模拟的方法，对汽车无级自动变速器CVT带轮和钢带的接触条件进行了模拟。 - Steel column is fixed to special jig, slipping below the installation position by chain block and lifting by pulley block and windlass.
将钢骨柱固定在专用胎架上，通过倒链滑移至安装点下方后，采用滑轮组和卷扬机进行提升就位。 - Under arraying rope pillar function, two pieces of pulley block circles pillar to do left, right nimble swinging, which cause rope winds in regular arrangement.
绳索在排绳柱作用下，两个滑轮组绕柱子左、右灵活摆动，使绳索在卷绳轴形成有规则的排列。 - The skillful design of the pulley block makes the largest door leaf able to bear the400kg dead load of the leaf.
滑轮组的巧妙设计，使最大门扇可承受400公斤的门扇自重。 - The wire rope model of multiple magnification pulley block is built and simplified. The impaction about hook block is simulated by ADAMS software. The impact and the pressure on main hoist load girder were obtained.
研究多倍率滑轮组钢丝绳的建模和简化方法，利用ADAMS软件进行吊钩组冲顶动力学仿真，得到了吊钩组冲顶载荷及拉紧钢丝绳对主起升承载梁的压力载荷。 - It is an economical, reasonable and convenient hoisting method to use crab, pulley block and bridge crane to hoist the generator stator to the location. The key is to assure the safety and reliability of hoisting equipment.
利用卷扬机、滑轮组、提升承重架和行车将发电机定子吊装就位是既经济合理，又方便的吊装方法，其关键是保证吊装装置安全可靠。 - Hoisting of Pipe Bundle of Extraneous Heat Remover at Catalytic Equipment Using Pulley Block
巧设滑车组吊装催化装置外取热器管束 - Fasten the pulley and the support block to your worktable.
拴紧对你的工作台的滑车和支承区块。 - A pulley or a system of pulleys set in a casing. A block and tackle is needed to lift that heavy machine.
要吊起那么重的机器需要使用一个滑轮组。 - With the purposes of optimizing engineering, it is proved to be the best position for installing pulley on girder of crabon block stacking carne, and figure out the optimum geometric arrangement of clamp rod in the paper.
本文从优化设计的角度出发，证明了炭块堆垛天车夹具横梁上的滑轮安装的最佳位置，并找出了夹具杆件的最佳几何布局。